To effectively use node classifications, you must map listeners to node types. When you start a node with a specific node type, the node runs only the listeners that are associated with that node type.
-
In the navigation panel of Dev Studio, click , and then click the listener that you want to configure: Email
Listener, File Listener, JMS
Listener, or MQ Listener.
-
Click the name of a listener in the list to open its rule form.
-
In the Listener nodes section on the
Properties tab, select NodeClassification based
startup from the Startup option list.
Note: If you do not see the Startup option list, clear the
Block startup check box.
-
In the Classification section, click the
Plus icon to add a node type.
-
In the Node Type field, press the Down Arrow key and select a
node type from the list. Only the allowed node types are shown. The listener runs for all
the nodes that are started with the node type or types that you select.
- Optional:
Repeat these steps to add another node type to the same listener.
-
Click Save.
Result:
Note: To run the listener on all the node types, select Run on all
nodes from the Startup option list and save the rule
form.