Calculator Interrogation


I am learning "Pega Robotic System Architect Essentials" training material.

Now I am trying to interrogate calculator available in my desktop. When I start interrogation, application is launched but interrogation stopped. I couldn't interrogate any controls in calculator. I looked at few queries posted previously but I could't resolve this. Can someone provide me any solution. I couldn't understand why this happens.


Keep up to date on this post and subscribe to comments

August 16, 2019 - 6:57am

Please refer below link, which might be helpful as Calc is not supported. Please try to open notepad and let us know if the interrogation form is still closing or not.

August 16, 2019 - 7:20am

Thanks for your response!

I tried for Notepad, I'm able to interrogate the TextBox control. I don't find the same problem in Notepad.

I'm using Pega Robotics Studio 8.0.2014.0 which was available in the online training material. I viewed at the link posted above, where Pega Robotics version 8.0.1061 was suggested to install. Is that the only solution to resolve this. If so, please provide me details where I can find the suggested version.

August 16, 2019 - 9:23am
Response to Suganyak1359

Above link say's that Calculator is not supported from windows 10. So please let us know the exact version of OS in which Robotics was installed. To get exact version of OS, open command prompt, then type winver. you will be getting a window showing the exact OS version. Also above link specifies about a solution on notpad.exe but not on calc.exe

August 19, 2019 - 12:56am
Response to Aditya Menda

 I looked at My OS version and it is 1703. Also I didn't face this issue while interrogating calc.exe