7.31 Pege-set-Message not dispensing in UI(Perform harness)

Hi Every One, My Project recently upgraded 6.1 to 7.3.1. In new environment all places Pege-set-Message is not displaying UI. Saw some articles says need hot fix for this. Did some one used this hot fix or SR. Please help me on this.


Keep up to date on this post and subscribe to comments

May 21, 2019 - 11:16pm

Hi , 

I believe you are talking about the below mentioned SA:

This issue states that error messages are not shown in a modal dialog after upgrade to Pega 7.3.1. If your use case is similar then please go ahead and create a SR-Media request for the hotfix.

If your use case is slightly different please attach screenshots describing your issue.